Link E-Throttle Remote Controller (RET)

Link E-Throttle Remote Controller (RET)

Available from JDM Mods NQ, the Link E-Throttle Remote Controller (RET) is a throttle-control component for an appropriately configured engine-management system. Use the fitment, technical and package details below to select the correct part for your build.

Manufacturer part number: 115-1000

Models Supported

• Link G4+ Storm, Xtreme, Fury and Plug-in ECUs.
• Link G4X MonsoonX, StormX and Plug-inX ECUs.
• Link G4X XtremeX and FuryX ECUs for secondary e-throttle applications.
• Single and dual electronic throttle applications.

Warnings

• Requires three ECU auxiliary outputs for operation.
• The enable input must be driven low to activate the module.

Highlights

• Adds electronic throttle (drive by wire) control to compatible Link ECUs.
• Supports primary or secondary e-throttle control.
• Designed and manufactured by LinkECU.
• Compact remote-mount design.
• Requires three ECU auxiliary outputs.
• Includes wiring loom.

Electrical

• Operating Voltage Range: 6-23V
• Maximum Input Voltage: 37V
• Maximum Continuous Current Draw: 6A

Installation and ordering

Confirm connector type, wiring, supply voltage and compatibility with the ECU or connected device before purchase. Follow the relevant Link wiring diagram, calibration and mounting instructions. CAN devices require a compatible CAN configuration and correct bus termination. Accessories are included only where they are explicitly listed below.

Installation and Compatibility Checks

Confirm the specified device compatibility, connectors and installation requirements before ordering. Use a qualified installer for vehicle electrical work.